How-To - Page 3 of 255

Using jam chucks at the lathe
January 30, 2024

Darryl Jones shows an example of how a jam chuck can overcome work-holding challenges at the lathe.
Throwback: How to Hew a Beam in 10 Steps
January 25, 2024

Tackle traditional work without aging your body
Throwback: How to sharpen a handsaw
January 5, 2024

The principles, procedures, and gadgets to make rip and crosscut saws cut like new
Dentil Moldings for Fine Furniture
January 3, 2024

Learn how to lay out Greek key and standard block dentil moldings in Part I of our two-part series
Basic shopmade banding
December 22, 2023

Commonly found in Federal-style furniture, Steve Latta's basic block banding is a great way to embellish all furniture, whether period or contemporary.
The essential table saw crosscut sled
December 8, 2023

Bob Van Dyke's crosscut sled delivers accuracy and versatility without bells, whistles, or lots of measuring and fussing.
Ep 19: Cutting curved seat rail rabbets
December 7, 2023

Using hand tools, Dan deftly cuts the curved rabbets that will eventually hold the seat of the Queen Anne chair.
Tackle full-length rabbets at the table saw
November 24, 2023

Learn how to cut rabbets with a dado set on the tablesaw.
Some projects need more than drawings
November 13, 2023

Always have your notes handy.
How to set up big woodworking machines
November 7, 2023

Whether you are acquiring a new table saw, a jointer, a lathe, or some other machine, it helps to use best practices from the moment it arrives in your shop.

Page 3 of 255 Previous

1
2
3
4
5
255

Next

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.